Enterasys 1G58x-09 - Clear Trunk Port; Set Trunk Port

Port Configuration Command Set
Configuring Static Port Trunking
4-56 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
4.3.11.5 set trunk port
Use this command to add one or more trunk ports to an existing trunk when the device is set to port
trunking mode
.
set trunk port trunk_name port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to add Fast Ethernet front panel ports 3 through 6 to the “blue” trunk:
4.3.11.6 clear trunk port
Use this command to remove a port from a trunk when the device is set to port trunking mode.
clear trunk port trunk_name port-string
trunk_name Specifies the name of the trunk to which the trunk port
will be added.
port-string Specifies the designation of the port(s) to be added to the
trunk. For a detailed description of possible port-string
values, refer to Section 4.1.2.
Matrix>set trunk port blue fe.0.3-6