IGMP Configuration Command Set
Configuring IGMP VLAN Registration
10-12 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Example
This example shows how to set the IGMP mode IP address to 10.1.2.3:
10.2.4.4 set igmp mode
Use this command to configure IVR ports as open or secure. Open ports will scope multicast
transmissions to the IGMP VLAN. These ports are user access ports subscribing to receive
multicast streams via the IGMP registered VLAN specified in the set igmp mode vlan command
(Section 10.2.4.2). Ports in secure mode will scope multicast transmissions to the VLAN receiving
the IGMP requests.
set igmp mode port-string {open | secure}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the IGMP mode to open for front panel Fast Ethernet ports 1 through
3:
Matrix>set igmp mode ipaddress 10.1.2.3
port-string Specifies port(s) for which to set IGMP mode. For a
detailed description of possible port-string values, refer
to Section 4.1.2.
open | secure Specifies the port(s) IGMP mode as open (scoping to the
IGMP VLAN), or secure (scoping to the VLAN receiving
IGMP requests).
Matrix>set igmp mode fe.0.1-3 open
To Next Page
Loading...