Security Configuration Command Set
Configuring Flow Setup Throttling (FST)
14-106 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Defaults
None.
Example
This example shows how to enable FST on Fast Ethernet front panel ports 1-5:
14.3.9.3 set flowlimit limit
Use this command to set a flow limit and an action for a port user classification. Once configured,
this action can be assigned to one or more ports using the set flowlimit class command as described
in Section 14.3.9.4.
set flowlimit limit {1 | 2} {aggregationport | interswitchlink | serverport |
unspecified | userport} limit [discard | drop | trap | disable]}
Syntax Description
Matrix>set flowlimit fe.0.1-5 enable
1 | 2 Specifies this configuration as action 1 or 2. Two actions
describing what will occur when a certain flow limit is
reached can be defined per user classification.
aggregationport |
interswitchlink |
serverport |
unspecified |
userport
Assigns this action configuration to the user classification
port type:
• aggregation port
• inter-switch link
• server port
• user port
• unspecified port
limit Specifies the number of flows that will trigger this action
configuration. Valid values are 0 - 128000.
To Next Page
Loading...