Security Configuration Command Set
Configuring 802.1X Authentication
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 14-23
14.3.2.5 set dot1x port
Use this command to enable 802.1X reauthentication or initialization control on one or more ports.
set dot1x port port-string [init | reauth]
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
If not specified, both initialization control and reauthentication on specified ports.
Example
This example shows how to enable reauthentication control on ports fe.0.1-5,:
port-string Specifies the port(s) on which to enable reauthentication or
reauthentication. For a detailed description of possible
port-string values, refer to Section 4.1.2.
init | reauth (Optional) Enables initialization control or
reauthentication.
Matrix>set dot1x port fe.0.1-5 reauth
To Next Page
Loading...