Port Configuration Command Set
Configuring Static Port Trunking
4-54 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
4.3.11.2 set trunkmode
Use this command to toggle the trunking mode on the device from the default (802.3ad) to port
trunking, which allows the device to recognize statically created port trunks.
set trunkmode {8023ad | porttrunking}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how enable port trunking mode on the device:
4.3.11.3 set trunk
Use this command to create, enable or disable a trunk when the device is set to port trunking mode.
set trunk trunk_name {create | disable | enable}
Syntax Description
Command Defaults
None.
8023ad Enables 802.3ad link aggregation mode.
porttrunking Enables manual port trunking mode.
Matrix>set trunkmode porttrunking
trunk_name Specifies the name of the trunk port to be created,
disabled or enabled.
create | disable |
enable
Creates, disables or enables a trunk with the specified
name.
To Next Page
Loading...
Need help?
General