SNMP Command Set
Configuring SNMP Notification Parameters
5-58 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Defaults
• If not specified, mask is set to 255.255.255.255
• If not specified, subtree will be included.
• If storage type is not specified, nonvolatile will be applied.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to create an SNMP notify filter called “noauthentication” with a MIB
subtree ID of 1, to include all management targets:
This example shows how to create an SNMP notify filter called “pilot1” with a MIB subtree ID of
1.3.6:
5.2.7.11 clear snmp notifyfilter
Use this command to delete an SNMP notify filter configuration.
clear snmp notifyfilter profile subtree oid
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Matrix>set snmp notifyfilter noauthentication subtree 1 included
nonvolatile
Matrix>set snmp notifyfilter pilot1 subtree 1.3.6
profile Specifies an SNMP filter notify name to delete.
subtree oid Specifies a MIB subtree containing the filter to be
deleted.
To Next Page
Loading...
Need help?
General