Logging and Network Management Command Set
Managing Switch Network Addresses
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-47
11.2.3.14clear port stopaging
Use this command to reset the stop aging function on one or more ports to the default state of
disabled.
clear port stopaging [port-string]
Syntax Description
Command Defaults
If port-string is not specified, status for all ports will be reset.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the stop aging function to disabled on Fast Ethernet front panel
ports 1 through 8:
11.2.3.15set mac algorithm
Use this command to set the MAC algorithm mode, which determines the hash mechanism used by
the device when performing layer 2 lookups on received frames. Each algorithm is optimized for a
different spread of MAC addresses.
set mac algorithm {mac-random | mac-sequential | mac-vid-random |
mac-vid-sequential}
port-string (Optional) Resets the stop aging function on specific
port(s). For a detailed description of possible port-string
values, refer to Section 4.1.2.
Matrix>clear port stopaging fe.0.1-8
NOTE: The Matrix E1 Series devices cannot support routing interfaces when the MAC
algorithm is set to mac-random or mac-sequential. If you choose either of these
modes, the Matrix E1 will display a warning message and prompt you to restart the
device.
To Next Page
Loading...