Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
11-76 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Examples
This example shows how to display CEP status for each detection type on port ge.0.1. In this case
the default state of disabled for each type has not been changed:
This example shows default CEP policy information. In this case, no policies have been configured
for the three CEP detection types:
11.2.6.2 set cep
Use this command to globally enable or disable CEP detection.
set cep {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Matrix>show cep port ge.0.1
CEP Detection: - disabled
ge.0.1
H323 phone - disabled
Siemens phone - disabled
Cisco phone - disabled
Matrix>show cep policy
CEP default policies
CEP Type Policy Index Policy Name
-------- ------------ ------------
H323
Siemens
Cisco
enable | disable Globally enables or disables CEP detection.
To Next Page
Loading...
Need help?
General