Port Configuration Command Set
Setting Flow Control and Thesholds
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 4-29
4.3.6.2 set port flowcontrol
Use this command to enable or disable flow control for one or more ports. Note that you cannot
execute this command if auto-negotiation is enabled.
set port flowcontrol port-string {disable | enable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable flow control on Fast Ethernet front panel ports 21 through 24:
port-string Specifies the port(s) for which to enable or disable flow
control. For a detailed description of possible port-string
values, refer to Section 4.1.2.
disable | enable Disables or enables flow control.
Matrix>set port flowcontrol fe.0.21-24 enable
To Next Page
Loading...