Enterasys 1G58x-09 - Clear Priority Classification Ingress

Port Priority and Classification Configuration Commands
Classification Precedence Rules
9-32 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Example
This example shows how to add Fast Ethernet front panel ports 30 through 33 to the Ethernet II
Type IP classification rule:
9.3.5.2 clear priority classification ingress
Use this command to remove ports from a priority classification rule.
clear priority classification ingress priority_value port-string data_meaning
data_value [data_mask]
Syntax Description
Command Defaults
Data masks are required only for classification types requiring a second
data_value. For details, refer to Table 9-1.
Command Type
Switch command.
Matrix>set priority classification ingress 7 fe.0.30-33 ethernet-II-type IP
priority_value Specifies the number of the port priority (0 through 7)
being removed from the priority ingress classification list.
port-string Specifies the port(s) being removed from the port priority
ingress classification list. For a detailed description of
possible port-string values, refer to Section 4.1.2.
data_meaning The data_meaning of the classification ingress entry to be
cleared. Refer to Table 9-1 for the list of the
data_meaning numbers and associated protocol types and
classifications.
data _value Specifies the data_value of the classification ingress entry
to be cleared. The range of codes is dependent on the
data_meaning. Refer to Table 9-1 for the limitations.
data_mask (Not required for most data values) Specifies a value
dependent on the data_value entered. For details, refer to
Table 9-1.