General Configuration Command Set
Managing Switch Configuration Files
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-57
3.2.5 Managing Switch Configuration Files
Purpose
To view, manage, and execute configuration files when operating in switch mode.
Commands
The commands needed to view, manage, and execute switch configuration files are listed below and
described in the associated section as shown.
• dir (Section 3.2.5.1)
• show config (Section 3.2.5.2)
• configure (Section 3.2.5.3)
• summaryconfig (Section 3.2.5.4)
• copy (Section 3.2.5.5)
• set system bootconfig (Section 3.2.5.6)
• delete (Section 3.2.5.7)
3.2.5.1 dir
Use this command to display CLI configuration files stored in NVRAM.
dir [all]
Syntax Description
Command Type
Switch command.
Command Mode
Read-only.
Command Defaults
If all is not specified, only configuration files stored in the NVDRIVE: file system
will be displayed.
all (Optional) Displays all files in the NVDRIVE: file system.
To Next Page
Loading...
Need help?
General