VLAN Configuration Command Set
Assigning Port VLAN IDs (PVIDs) and Ingress Filtering
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 7-13
7.3.3 Assigning Port VLAN IDs (PVIDs) and Ingress Filtering
Purpose
To assign default VLAN IDs to untagged frames on one or more ports. Using set port vlan you can,
for example, assign ports 1, 5, 8, and 9 to VLAN 3. Untagged frames received on those ports will
be assigned to VLAN 3. (By default, all ports are members of VLAN ID 1, the default VLAN.)
However, if VLAN classification is enabled and the received frame matches a classification rule,
the frame is assigned to the Port VLAN ID defined in the classification rule and not the Port VLAN
ID assigned to the port. VLAN classification takes precedence over the PVID.
Commands
The commands associated with configuring port VLAN IDs are listed below and described in the
associated section as shown.
• show port vlan (Section 7.3.3.1)
• set port vlan (Section 7.3.3.2)
• clear port vlan (Section 7.3.3.3)
• show port ingress filter (Section 7.3.3.4)
• set port ingress filter (Section 7.3.3.5)
7.3.3.1 show port vlan
Use this command to display which VLANs are on one or all port VLAN lists.
show port vlan [port-string]
Syntax Description
Command Defaults
If port _string is not specified, all port VLAN information will be displayed.
Command Type
Switch command.
port-string (Optional) Displays the VLAN list for specific port(s).
For a detailed description of possible port-string values,
refer to Section 4.1.2.
To Next Page
Loading...
Need help?
General