SNMP Command Set
Configuring SNMP Target Addresses
5-44 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
5.2.6.2 set snmp targetaddr
Use this command to set an SNMP target address configuration. The target address is a unique
identifier and a specific IP address that will receive SNMP notification messages. This address
configuration can be linked to optional SNMP transmit parameters (such as timeout, retry count,
and UDP port).
set snmp targetaddr targetaddr param param ipaddress ipaddr [port udpport]
[timeout timeout] [retries retries] [volatile | nonvolatile] [taglist tagname]
Parameters Entry in the snmpTargetParamsTable.
Storage type Whether entry is stored in volatile, nonvolatile or
read-only memory.
Row status Status of this entry: active, notInService, or
notReady.
Table 5-10 show snmp targetaddr Output Details (Continued)
Output What It Displays...
To Next Page
Loading...
Need help?
General