IP Configuration Command Set
Reviewing and Configuring the ARP Table
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 12-19
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router(config-if(Vlan <vlan_id>))#
Command Defaults
None.
Example
The following example shows how to enable proxy ARP on VLAN 1:
12.2.3.5 ip mac-address
Use this command to set a MAC address on an interface.
ip mac-address address
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command clears the MAC address:
no ip mac-address
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router(config-if (Vlan <vlan_id>))#
Command Defaults
None.
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip proxy-arp
address Specifies a 48-bit MAC address in hexadecimal format.
To Next Page
Loading...