Enterasys 1G58x-09 - Clear Spantree Autoedge; Set Spantree Autoedge

Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
6-28 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
6.2.1.28 set spantree autoedge
Use this command to enable or disable the automatic edge port detection function.
set spantree autoedge {disable | enable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable automatic edge port detection:
6.2.1.29 clear spantree autoedge
Use this command to reset automatic edge port detection to the default state of enabled.
clear spantree autoedge
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
disable | enable Disables or enables automatic edge port detection.
Matrix>set spantree autoedge disable