Security Configuration Command Set
Configuring MAC Locking
14-46 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
14.3.4.2 show maclock stations
Use this command to display MAC locking information about end stations connected to the device.
show maclock stations [port-string] [firstarrival | firstarrival port-string] [static
| static port-string]
Table 14-5 show maclock Output Details
Output What It Displays...
Port Number Port designation. For a detailed description of possible
port-string values, refer to Section 4.1.2.
Port Status Whether MAC locking is enabled or disabled on the port.
MAC locking is globally disabled by default. For details on
using set maclock commands to enable it on the device and
on one or more ports, refer to Section 14.3.4.3 and
Section 14.3.4.5.
Trap Status Whether MAC lock trap messaging is enabled or disabled
on the port. For details on setting this status using the set
maclock trap command, refer to Section 14.3.4.17.
Max Static
Allocated
The maximum static MAC addresses allowed locked to the
port. For details on setting this value using the set maclock
static command, refer to Section 14.3.4.7.
Max FirstArrival
Allocated
The maximum end station MAC addresses allowed locked
to the port. For details on setting this value using the set
maclock firstarrival command, refer to Section 14.3.4.6.
Violating MAC
Address
Any MAC address(es) violating the maximum static and
first arrival value(s) set for the port.
To Next Page
Loading...
Need help?
General