General Configuration Command Set
Managing Switch Configuration Files
3-66 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
This example shows how to download and execute the clitxt.txt file. This command will reset the
device:
This example shows how to download and execute the cliappend.txt file. This command will not
reset the device:
3.2.5.6 set system bootconfig
Use this command to select the configuration file the device will load at startup.
set system bootconfig {flash | network file-location}
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
None.
Example
This example shows how to set the boot configuration file to flash:
Matrix>copy tftp://10.1.129.3/config/clitxt.txt device-config
Matrix>copy tftp://10.1.29.3/config/cliappend.txt device-config append
flash Loads the flash configuration file.
network
file-location
Specifies a network file location from which to load the
configuration file.
Matrix>set system bootconfig flash
To Next Page
Loading...