Enterasys 1G58x-09 - Clear Snmp Targetaddr

SNMP Command Set
Configuring SNMP Target Addresses
5-46 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Example
This example shows how to set an SNMP target address of “1” associated with a parameter called
v1ExampleParams on IP address 127.0.0.1 and UDP port 160:
5.2.6.3 clear snmp targetaddr
Use this command to delete an SNMP target address entry.
clear snmp targetaddr targetAddr
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to clear SNMP target address entry “1”:
Matrix>set snmp targetaddr 1 param v1ExampleParams ipaddress 127.0.0.1 udp 160
targetAddr Specifies the target address entry to delete.
Matrix>clear snmp targetaddr 1