Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
6-4 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
6.2 SPANNING TREE CONFIGURATION COMMAND SET
6.2.1 Reviewing and Setting Spanning Tree Bridge Parameters
Purpose
To display and set Spanning Tree bridge parameters, including device priorities, hello time,
maximum age time, forward delay, path cost, topology change trap suppression, maximum hop
count, and transmit hold count.
Commands
The commands needed to review and set Spanning Tree bridge parameters are listed below and
described in the associated section as shown.
• show spantree stats (Section 6.2.1.1)
• set spantree (Section 6.2.1.2)
• show spantree version (Section 6.2.1.3)
• set spantree version (Section 6.2.1.4)
• clear spantree version (Section 6.2.1.5)
• show spantree mstilist (Section 6.2.1.6)
• set spantree msti (Section 6.2.1.7)
• clear spantree msti (Section 6.2.1.8)
• show spantree mstmap (Section 6.2.1.9)
• set spantree mstmap (Section 6.2.1.10)
• clear spantree mstmap (Section 6.2.1.11)
• show spantree vlanlist (Section 6.2.1.12)
• show spantree mstcfgid (Section 6.2.1.13)
• set spantree mstcfgid (Section 6.2.1.14)
• clear spantree mstcfgid (Section 6.2.1.15)
• set spantree priority (Section 6.2.1.16)
• clear spantree priority (Section 6.2.1.17)
• show spantree bridgehellomode (Section 6.2.1.18)
To Next Page
Loading...
Need help?
General