Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Port Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 6-37
• clear spantree spanguardtimeout (Section 6.2.2.19)
• show spantree spanguardlock (Section 6.2.2.20)
• clear spantree spanguardlock (Section 6.2.2.21)
• show spantree spanguardtrapenable (Section 6.2.2.22)
• set spantree spanguardtrapenable (Section 6.2.2.23)
• clear spantree spanguardtrapenable (Section 6.2.2.24)
• show spantree adminpoint (Section 6.2.2.25)
• set spantree adminpoint (Section 6.2.2.26)
• clear spantree adminpoint (Section 6.2.2.27)
6.2.2.1 show spantree portadmin
Use this command to display the status of the Spanning Tree algorithm on one or more ports.
show spantree portadmin port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
port-string Specifies port(s) for which to display status. For a
detailed description of possible port-string values, refer
to Section 4.1.2.
To Next Page
Loading...
Need help?
General