Logging and Network Management Command Set
Monitoring Switch Network Events and Status
11-24 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
11.2.2.3 history
Use this command to display the contents of the command history buffer. The command history
buffer includes all the switch commands entered up to a maximum of 32, as specified in the set
history command (Section 11.2.2.6).
history
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the contents of the command history buffer. It shows there are
five commands in the buffer:
11.2.2.4 repeat
Use this command to repeat a command shown in the command history buffer.
repeat [cmd_num] [iterations]
Matrix>history
1 show arp
2 history
3 show ip
4 show cdp fe.0.1
5 history
To Next Page
Loading...
Need help?
General