Logging and Network Management Command Set
Managing Switch Network Addresses
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-35
11.2.3.1 show arp
Use this command to display the switch’s ARP table.
show arp
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the ARP table:
11.2.3.2 set arp
Use this command to add mapping entries to the switch’s ARP table.
set arp ip_address mac_address [temp] [pub] [trail]
Matrix>show arp
LINK LEVEL ARP TABLE
destination gateway flags Refcnt Use Interface
--------------------------------------------------------------------------
10.1.0.1 00:00:1d:bc:df:bf 405 1 0 host0
10.1.10.10 00:00:1d:1f:27:26 405 0 11338 host0
--------------------------------------------------------------------------
To Next Page
Loading...