Logging and Network Management Command Set
Configuring Simple Network Time Protocol (SNTP)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-61
Example
This example shows how to display SNTP settings. In this case, SNTP is operating in unicast mode.
Broadcast delay is set at the default of 3000 milliseconds and SNTP requests are being transmitted
every 512 seconds. Two servers, one with IP address 10.21.1.100, and another with host name
“roadking” are configured as SNTP servers:
11.2.4.2 set sntp client
Use this command to set the SNTP operation mode.
set sntp client {broadcast | unicast | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Matrix>show sntp
SNTP Version: 3
Current Time: Thursday April 3, 2003 09:42:54
Timezone: 'EST', offset from UTC is -5 hours and 0 minutes
Last SNTP update: Wednesday April 2, 2003 11:02:48
Client mode: broadcast
Broadcast delay: 3000
Poll Interval: 512
SNTP Requests: 10
Last SNTP Request: Thursday, April 3, 2003 09:32:54
SNTP- Servers
------------------
10.21.1.100
roadking
broadcast Enables SNTP in broadcast client mode.
unicast Enables SNTP in unicast (point-to-point) client mode. In
this mode, the client must supply the IP address from which
to retrieve the current time.
disable Disables SNTP.
To Next Page
Loading...
Need help?
General