Enterasys 1G58x-09 User Manual

General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
3-70 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
3.2.6.2 set cdp
Use this command to enable or disable the Enterasys Discovery Protocol on one or more ports.
set cdp {auto | disable | enable} [port-string]
Table 3-6 show cdp Output Details
Output What It Displays...
CDP Version Current Enterasys Discovery Protocol version number.
Global CDP State Whether Enterasys Discovery Protocol is globally
auto-enabled, enabled or disabled.
Global Hold Time Transmit frequency (in seconds) of Enterasys Discovery
Protocol messages. For details on using the set cdp interval
command to change the default value of 60, refer to
Section 3.2.6.2.
Port Port designation. For a detailed description of possible
port-string values, refer to Section 4.1.2.
State Whether Enterasys Discovery Protocol is enabled, disabled
or in auto mode on this port. For details on using the set cdp
command to change the default setting of auto, refer to
Section 3.2.6.2.

Enterasys 1G58x-09 Specifications

General

Brand	Enterasys
Model	1G58x-09
Category	Network Hardware
Language	English