Spanning Tree Configuration Summary
Process Overview: Spanning Tree Configuration
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 6-3
6.1.3 Process Overview: Spanning Tree Configuration
Use the following steps as a guide in the Spanning Tree configuration process:
1. Reviewing and setting Spanning Tree bridge (device) parameters (Section 6.2.1)
2. Reviewing and setting Spanning Tree port parameters (Section 6.2.2)
CAUTION: Spanning Tree configuration should be performed only by personnel who
are very knowledgeable about Spanning Trees and the configuration of the Spanning
Tree Algorithm. Otherwise, the proper operation of the network could be at risk.
NOTE: The term “bridge” is used as an equivalent to the term “switch” or “device” in this
document.
To Next Page
Loading...
Need help?
General