Enterasys 1G58x-09 - Reviewing and Configuring the ARP Table; Show Ip Arp

IP Configuration Command Set
Reviewing and Configuring the ARP Table
12-14 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
12.2.3 Reviewing and Configuring the ARP Table
Purpose
To review and configure the routing ARP table, to enable proxy ARP on an interface, and to set a
MAC address on an interface.
Commands
The commands needed to review and configure the ARP table are listed below and described in the
associated section as shown:
• show ip arp (Section 12.2.3.1)
• arp (Section 12.2.3.2)
• ip gratuitous-arp-learning (Section 12.2.3.3)
• ip proxy-arp (Section 12.2.3.4)
• ip mac-address (Section 12.2.3.5)
• arp timeout (Section 12.2.3.6)
• clear arp-cache (Section 12.2.3.7)
12.2.3.1 show ip arp
Use this command to display entries in the ARP (Address Resolution Protocol) table. ARP converts
an IP address into a physical address.
show ip arp [ip_address] [vlan vlan_id] [output-modifier]