Enterasys 1G58x-09 - Set Priority Classification Ingress

Port Priority and Classification Configuration Commands
Classification Precedence Rules
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 9-31
9.3.5.1 set priority classification ingress
Use this command to add ports to a priority classification rule. These ports will then be active for
this rule.
set priority classification ingress priority_value port-string data_meaning
data_value [data_mask]
Syntax Description
Command Defaults
Data masks are required only for classification types requiring a second
data_value. For details, refer to Table 9-1.
Command Type
Switch command.
Command Mode
Read-Write.
priority_value Specifies the number of the port priority (0 through 7)
being associated with the priority ingress classification
list.
port-string Specifies the port(s) being added to the port priority
ingress classification list. For a detailed description of
possible port-string values, refer to Section 4.1.2.
data_meaning Specifies the data_meaning for the parameter used to
classify frames. Refer to Table 9-1 for the list of the
data_meanings and associated protocol types and
classifications.
data _value Specifies the code of a predefined classifier. The range of
codes is dependent on the data_meaning. Refer to
Table 9-1 for the limitations.
data_mask (Not required for most data values) Specifies a value
dependent on the data_value entered. For details, refer to
Table 9-1.