Enterasys 1G58x-09 - Set Snmp Targetparams

SNMP Command Set
Configuring SNMP Target Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 5-39
5.2.5.2 set snmp targetparams
Use this command to set SNMP target parameters, a named set of security/authorization criteria
used to generate a message to a target.
set snmp targetparams paramsname user user security-model {v1 | v2c | v3}
message-processing {v1 | v2c | v3} {noauthentication | authentication |
privacy} [volatile | nonvolatile]
Security Level Type of security level. Valid levels are:
• noauth — No authentication or privacy
protocol required.
• auth — Authentication but no privacy protocol
required.
• authpriv — Authentication and privacy
protocol required.
Storage type Whether entry is stored in volatile, nonvolatile or
read-only memory.
Row status Status of this entry: active, notInService, or
notReady.
Table 5-9 show snmp targetparams Output Details (Continued)
Output What It Displays...