General Configuration Command Set
Resetting the Device
3-88 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Example
This command shows how to display reset information
3.2.8.2 reset
Use this command to reset the device immediately, cancel, or display information about a scheduled
reset.
reset [system [cancel]] [show]
Syntax Description
Command Defaults
If no parameters are specified, the system will be reset.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to reset the system immediately:
Matrix>show reset
Reset scheduled for Fri Jan 21 2004, 23:00:00 (in 3 days 12 hours 56 minutes 57
seconds).
Reset reason: Software upgrade
system (Optional) Resets the system.
cancel (Optional) Cancels a reset scheduled using the reset at
command as described in Section 3.2.8.3, or the reset in
command as described in Section 3.2.8.4.
show (Optional) Displays information about a scheduled reset.
Matrix>reset
This command will reset the device.
Do you want to continue (y/n)
[n]? y
Resetting device...
To Next Page
Loading...