SNMP Command Set
Disabling / Enabling and Reviewing SNMP Statistics
5-6 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Example
This example shows how to display SNMP status:
5.2.1.2 set snmp
Use this command to enable or disable SNMP management on the device.
set snmp {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable SNMP:
5.2.1.3 show snmp engineid
Use this command to display the SNMP local engine ID. This is the SNMP v3 engine’s
administratively unique identifier.
show snmp engineid
Syntax Description
None.
Command Defaults
None.
Matrix>show snmp
SNMP is currently enabled.
enable | disable Enables or disables SNMP management.
Matrix>set snmp disable
To Next Page
Loading...
Need help?
General