Enterasys 1G58x-09 - Resetting the Device; Show Reset

General Configuration Command Set
Resetting the Device
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-87
3.2.8 Resetting the Device
Purpose
To reset the device without losing any user-defined switch and router configuration parameters, or
to clear NVRAM (user-defined) config settings.
Commands
Commands to reset the device are listed below and described in the associated section as shown.
• show reset (Section 3.2.8.1)
• reset (Section 3.2.8.2)
• reset at (Section 3.2.8.3)
• reset in (Section 3.2.8.4)
• clear config (Section 3.2.8.5)
3.2.8.1 show reset
Use this command to display information about scheduled device resets.
show reset
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.