Enterasys 1G58x-09 - Show Cdp

General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-69
3.2.6.1 show cdp
Use this command to display the status of the Enterasys (CDP) Discovery Protocol and message
interval on one or more ports.
show cdp [port-string]
Syntax Description
Command Defaults
If port-string is not specified, the CDP state for all ports will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display Enterasys Discovery Protocol for Fast Ethernet front panel
ports 3 through 11:
Table 3-6 provides an explanation of the command output.
port-string (Optional) Displays Enterasys Discovery Protocol
information for specific port(s). For a detailed description
of possible port-string values, refer to Section 4.1.2.
Matrix>show cdp fe.0.3-11
CDP Version : 6
Global CDP State : auto
Global Hold Time : 180
Port State Port State Port State
---------------------------------------------------------------
fe.0.3 auto fe.0.4 auto fe.0.5 auto
fe.0.6 auto fe.0.7 auto fe.0.8 auto
fe.0.9 auto fe.0.10 auto fe.0.11 auto