Enterasys 1G58x-09 - Set Port Advertised Ability

Port Configuration Command Set
Setting Port Auto-Negotiation and Advertised Ability
4-26 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
4.3.5.4 set port advertised ability
Use this command to enable or disable and to configure the advertised ability on one or more ports.
set port advertised ability port-string {10 | 100 | 1000 | all} {half | full | all}
{flowcontrol} {disable | enable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable Fast Ethernet front panel port 1 from advertising any speed or
duplex settings:
port-string Specifies the port(s) for which to enable, disable or
configure advertised ability. For a detailed description of
possible port-string values, refer to Section 4.1.2.
10 | 100 | 1000 |
all
Specifies a speed for the port to advertise in Mbps, or
enables the port to advertise all the speeds at which it can
operate.
half | full | all Specifies a duplex mode for the port to advertise, or enables
the port to advertise all the duplex modes at which it can
operate.
flowcontrol Specifies flow control for advertisement.
disable | enable Disables or enables advertised ability with the parameters
specified.
Matrix>set port advertised ability fe.0.1 all disable