Policy Classification Configuration Command Set
Assigning Classification Rules to Policy Profiles
8-18 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
8.3.2.6 show vlanauthorization
Use this command to displays the status of VLAN tunnel attribute processing during policy
authentication.
show vlanauthorization
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the status of VLAN authorization. In this case, it is globally
enabled, and enabled on all ports. No VLAN IDs have been configured for policy authentication:.
Matrix>show vlanauthorization
VLAN Authorization is globally enabled
Port Status VLAN Id
------- -------- ---------
fe.0.1 enabled 0
fe.0.2 enabled 0
fe.0.3 enabled 0
fe.0.4 enabled 0
fe.0.5 enabled 0
fe.0.6 enabled 0
fe.0.7 enabled 0
fe.0.8 enabled 0
fe.0.9 enabled 0
fe.0.10 enabled 0
fe.0.11 enabled 0
fe.0.12 enabled 0
fe.0.13 enabled 0
fe.0.14 enabled 0
fe.0.15 enabled 0
fe.0.16 enabled 0
--More--
To Next Page
Loading...
Need help?
General