Port Configuration Command Set
Setting Flow Control and Thesholds
4-30 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
4.3.6.3 show port buffer threshold
Use this command to display port buffer threshold settings.
show port buffer threshold
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display port buffer threshold settings. The output shows percentages
applied per port group for each priority queue within various ingress and egress threshold types, and
percentages applied for buffers within the EgressGeneral and IngressRx threshold types. For more
information on these threshold types and how to configure them using the set port buffer threshold
command, refer to Section 4.3.6.4:
Matrix>show port buffer threshold
! Fast Ethernet Gigabit Ethernet
! Priority Queue Priority Queue
! 0 1 2 3 0 1 2 3
Threshold
IngressHOL 50.0 50.0 50.0 50.0 : 50.0 50.0 50.0 50.0
IngressSoftHOL 25.0 25.0 25.0 25.0 : 25.0 25.0 25.0 25.0
EgressUniPrio 25.0 25.0 25.0 25.0 : 25.0 25.0 25.0 25.0
EgressMultiPrio 25.0 25.0 25.0 25.0 : 25.0 25.0 25.0 25.0
EgressAllPrio 100.0 100.0 100.0 100.0 : 100.0 100.0 100.0 100.0
EgressHOL 12.5 12.5 12.5 12.5 : 25.0 25.0 25.0 25.0
EgressSoftHOL 12.5 12.5 12.5 12.5 : 20.0 20.0 20.0 20.0
! Uni Multi Rtr Uni Multi Rtr
EgressGeneral 25.0 50.0 50.0 : 50.0 50.0 50.0
! Port FC On FC Off Port FC On FC Off
IngressRx 18.0 12.0 15.0 : 2.0 1.5 1.8
To Next Page
Loading...
Need help?
General