Enterasys 1G58x-09 - Enabling Router Configuration Modes

Preparing the Device for Router Mode
Enabling Router Configuration Modes
3-96 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
3.3.3 Enabling Router Configuration Modes
The Matrix E1 CLI provides different modes of router operation for issuing a subset of commands
from each mode. Table 3-10 describes these modes of operation.
NOTE: The command prompts used in examples throughout this guide show a system
where VLAN 1 has been configured for routing. The prompt changes depending on your
current configuration mode, and the interface types and numbers configured for routing
on your system.
Table 3-10 Router CLI Configuration Modes
Use this mode... To... Access method... Prompt...
Privileged EXEC
Mode
• Set system
operating
parameters
• Show
configuration
parameters
• Save/copy
configurations
Type router
from switch mode.
Matrix>Router#
Global
Configuration
Mode
Set system-wide
parameters.
Type
configure
terminal
from
Privileged EXEC
mode.
Matrix>Router(config)#
Interface
Configuration
Mode
Configure router
interfaces.
Type interface
and the interface’s
vlan_id from
Global
Configuration
mode.
Matrix>Router
(config-if(Vlan
<vlan_id>))#
Router
Configuration
Mode
Set IP protocol
parameters.
Type router
and the protocol
name from Global
or Interface
Configuration
mode.
Matrix>Router
(config-router)#