Preparing the Device for Router Mode
Enabling Router Configuration Modes
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-97
Key Chain
Configuration
Mode
Set protocol (RIP)
authentication key
parameters.
Type key chain
and the key chain
name
from Router
(RIP)
Configuration
mode.
Matrix>Router
(config-keychain)#
Key Chain Key
Configuration
Mode
Configure a specific
key within a RIP
authentication key
chain.
Type
key and the
key-id from Key
Chain
Configuration
Mode.
Matrix>Router
(config-keychain-key)#
NOTE: To jump to a lower configuration mode, type exit at the command prompt. To
revert back to switch mode, type exit from Privileged EXEC router mode.
Table 3-10 Router CLI Configuration Modes (Continued)
Use this mode... To... Access method... Prompt...
To Next Page
Loading...