Process Overview: Routing Protocol Configuration
Configuring OSPF
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 13-41
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command stops the routes from being summarized:
no area area-id range ip_address ip_mask
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router(config-router)#
Command Defaults
None.
Example
This example shows how to define the address range as 172.16.0.0/16 for summarized routes
communicated at the boundary of area 0.0.0.0:
13.1.2.15area authentication
Use this command to enable or disable authentication for an OSPF area.
area area-id authentication {simple | message-digest}
area-id Specifies the area at the boundary of which routes are to be
summarized.
ip_address Specifies the common prefix of the summarized networks.
ip_mask Specifies the length of the common prefix.
Matrix>Router(config)#router ospf 1
Matrix>Router(config-router)#area 0.0.0.0 range 172.16.0.0 255.255.0.0
To Next Page
Loading...
Need help?
General