EasyManuals Logo

Enterasys 1G58x-09 User Manual

Enterasys 1G58x-09
808 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #381 background imageLoading...
Page #381 background image
VLAN Configuration Command Set
Setting the Host VLAN
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 7-39
Example
This example shows how to display the host VLAN:
7.3.6.2 set port vlan host
Use this command to assign host status to a VLAN. The host VLAN should be a secure VLAN
where only designated users are allowed access. For example, a host VLAN could be specifically
created for device management. This would allow a management station connected to the
management VLAN to manage all ports on the device and make management secure by preventing
management via ports assigned to other VLANs.
set port vlan host vlan-id
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Command Alternative (v2.05.xx and previous)
set host vlan vlan-id
Matrix>show host vlan
Host vlan is 7.
NOTE: Before you can designate a VLAN as the host VLAN, you must create a VLAN
using the set of commands described in Section 7.3.2.
vlan-id Specifies the number of the VLAN to set as the host
VLAN.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Enterasys 1G58x-09 and is the answer not in the manual?

Enterasys 1G58x-09 Specifications

General IconGeneral
BrandEnterasys
Model1G58x-09
CategoryNetwork Hardware
LanguageEnglish