Enterasys 1G58x-09 - Configuring Access Lists; Show Access-Lists

To Next Page

To Previous Page

Security Configuration Command Set

Configuring Access Lists

Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 14-89

Command Mode

Read-Write.

Command Defaults

None.

Example

This example shows how to clear the SSH configuration:

14.3.7 Configuring Access Lists

Purpose

To review and configure security access lists (ACLs), which permit or deny access to routing

interfaces based on protocol and source IP address restrictions.

Commands

The commands needed to review and configure security access lists are listed below and described

in the associated section as shown:

• show access-lists (Section 14.3.7.1)

• access-list (standard) (Section 14.3.7.2)

• access-list (extended) (Section 14.3.7.3)

• ip access-group (Section 14.3.7.4)

14.3.7.1 show access-lists

Use this command to display configured IP access lists when operating in router mode.

show access-lists [access-list-number]

Matrix>clear ssh config

ROUTER: This command can be executed when the device is in router mode only.

For details on how to enable router configuration modes, refer to Section 3.3.3.