General Configuration Command Set
Setting Basic Device Properties
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-39
Example
This example shows how to set the system name to Information Systems:
3.2.2.11 set system location
Use this command to identify the location of the system.
set system location [“location_string”]
Syntax Description
Command Defaults
If location_string is not specified, the system location will be set to a blank string.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the system location string:
Matrix>set system name “Information Systems”
location_string (Optional) Specifies a text string that indicates where
the system is located. A location string containing a
space in the text must be enclosed in quotes as shown in
the example below.
Matrix>set system location “Bldg N32-04 Closet 9 Alpha Sierra”
To Next Page
Loading...