Logging and Network Management Command Set
Managing Switch Network Addresses
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-45
Example
This example shows how to reset the MAC aging time:
11.2.3.12show port stopaging
Use this command to display the status of the MAC address stop aging function on one or more
ports.
show port stopaging [port-string]
Syntax Description
Command Defaults
If port-string is not specified, status for all ports will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the status of the MAC address stop aging function on Fast
Ethernet front panel port 1. In this case, the default status of disabled (addresses are still aging out)
has not been changed:
Matrix>clear mac agingtime
port-string (Optional) Displays status for specified port(s). For a
detailed description of possible port-string values, refer to
Section 4.1.2.
Matrix>show port stopaging fe.0.1
Mac Address Aging
Port: Status:
====================
fe.0.1 Aging
To Next Page
Loading...