Enterasys 1G58x-09 - Set Spantree Adminedge

Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Port Parameters
6-46 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the edge port status for Fast Ethernet front panel port 3:
6.2.2.12 set spantree adminedge
Use this command to set the edge port administrative status on a Spanning Tree port.
set spantree adminedge port-string {true | false}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
port-string Specifies the port(s) for which to display edge
port administrative status. For a detailed
description of possible port-string values, refer to
Section 4.1.2
.
Matrix>show spantree adminedge fe.0.3
admin edge = TRUE for port fe.0.3
port-string Specifies the edge port. For a detailed description of
possible port-string values, refer to Section 4.1.2.
true | false Enables (true) or disables (false) the specified port as a
Spanning Tree edge port.