Logging and Network Management Command Set
Managing Switch Network Addresses
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-43
This example clears the scoping of the ingress MAC address 01:00:00:11:11:11 and VLAN 2 pair.
Then, the show mac multicast command is executed, to confirm that the scoping has been cleared.
11.2.3.9 show mac agingtime
Use this command to display the current MAC aging time setting.
show mac agingtime
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the MAC aging time. For a detailed description of this output,
refer back to Table 11-6:
Matrix> clear mac address 01-00-00-11-11-11 2
Matrix> show mac multicast
---------------------------------------------------------------
MAC Address Ingress VLAN Egress VLAN Counts : 1
---------------------------------------------------------------
01-00-00-11-11-11 5 3
Matrix>show mac agingtime
Filter Database Algorithm: mac-vid sequential
Current Filter Database Algorithm: mac-vid sequential
Aging Time : 300 seconds
Dynamic Address Counts : 5 Static Address Counts : 0
----------------------------------------------------------
MAC Address FID Port Type
----------------------------------------------------------
No Mac address entries available.
To Next Page
Loading...