EasyManuals Logo

Enterasys 1G58x-09 User Manual

Enterasys 1G58x-09
808 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #435 background imageLoading...
Page #435 background image
Port Priority and Classification Configuration Commands
Configuring Priority Classification
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 9-17
9.3.4.1 show priority classification
Use this command to display priority classification information.
show priority classification
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Command Alternative (v2.05.xx and higher)
show policy class (Section 8.3.2.1)
Example
This example shows that priority classification is currently enabled on the device and that two
priority classification entries have been created with a priority of 5. Currently, there are no ports on
the priority classification ingress list associated with these classification rules. The
ingress list is
created using the set priority classification ingress command described in Section 9.3.5.1.
Matrix>show priority classification
Priority Classification enabled.
Priority Classification Entries
--------------------------------
Priority: 5, Ethernet II Type: IP, Status: enabled,
Tos Value: 0, Tos Status: disabled,
Port List: None
----------
Priority: 5, Src UDP Range: 44-46, Status: enabled,
Tos Value: 0, Tos Status: disabled,
Port List: None

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Enterasys 1G58x-09 and is the answer not in the manual?

Enterasys 1G58x-09 Specifications

General IconGeneral
BrandEnterasys
Model1G58x-09
CategoryNetwork Hardware
LanguageEnglish