General Configuration Command Set
Managing Switch Configuration Files
3-58 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Example
This example shows how to display contents of the NVDRIVE: file directory:
3.2.5.2 show config
Use this command to display the contents of the CLI text configuration file.
show config [filename [all | system] [facility]]
Syntax Description
Command Type
Switch command.
Command Mode
Read-only.
Command Defaults
• If filename is not specified, the current CLI set commands will be regenerated
and spooled to the console.
• If all or system are not specified with a filename, the entire configuration file
will be displayed.
• If a facility is not specified, configurations for all known facilities will be
displayed.
Matrix>dir
Filename Filesize
------------------------
CLITXT.CFG 480
filename (Optional) Displays a specific file. The filename extension
must be .cfg
all (Optional) Displays the entire configuration file.
system (Optional) Displays only the CLI commands from the
configuration file.
facility (Optional) Displays the configuration for a specific facility.
For example, show config spantree would display only the
non-default Spanning Tree configuration.
To Next Page
Loading...
Need help?
General