General Configuration Command Set
Setting Basic Device Properties
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-43
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display daylight savings time settings:
3.2.2.17 set summertime
Use this command to enable or disable the daylight savings time function.
set summertime {enable | disable} [zone]
Syntax Description
Command Defaults
If a zone name is not specified, none will be applied.
Command Type
Switch command.
Command Mode
Read-Write.
Matrix>show summertime
Summertime is disabled and set to ''
Start : SUN APR 04 02:00:00 2004
End : SUN OCT 31 02:00:00 2004
Offset: 60 minutes (1 hours 0 minutes)
Recurring: yes, starting at 2:00 of the first Sunday of April and ending at 2:00
of the last Sunday of October
enable | disable Enables or disables the daylight savings time function.
zone (Optional) Applies a name to the daylight savings time
settings.
To Next Page
Loading...