Logging and Network Management Command Set
Configuring Node Aliases
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-67
11.2.5 Configuring Node Aliases
Purpose
To review, configure, disable and re-enable node (port) alias functionality, which determines what
network protocols are running on one or more ports.
Commands
Commands to configure node aliases are listed below and described in the associated section as
shown.
• show nodealias (Section 11.2.5.1)
• show nodealias config (Section 11.2.5.2)
• set nodealias (Section 11.2.5.3)
• set nodealias maxentries (Section 11.2.5.4)
• clear nodealias (Section 11.2.5.5)
• clear nodealias config (Section 11.2.5.6)
11.2.5.1 show nodealias
Use this command to display node alias properties on one or more ports.
show nodealias [port-string]
Syntax Description
Command Defaults
If port-string is not specified, node alias properties will be displayed for all ports.
Command Mode
Read-Only.
port-string (Optional) Displays node alias properties for specific
port(s). For a detailed description of possible port-string
values, refer to Section 4.1.2.
To Next Page
Loading...
Need help?
General