Enterasys 1G58x-09 - Configuring Simple Network Time Protocol (SNTP); Show Sntp

Logging and Network Management Command Set
Configuring Simple Network Time Protocol (SNTP)
11-60 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
11.2.4 Configuring Simple Network Time Protocol (SNTP)
Purpose
To configure the Simple Network Time Protocol (SNTP), which synchronizes device clocks in a
network. For other time-related commands, see Section 3.2.2, “Setting Basic Device Properties,”
on page 3-30.
Commands
Commands to configure SNTP are listed below and described in the associated section as shown.
• show sntp (Section 11.2.4.1)
• set sntp client (Section 11.2.4.2)
• set sntp broadcastdelay (Section 11.2.4.3)
• set sntp poll-interval (Section 11.2.4.4)
• set sntp server (Section 11.2.4.5)
• clear sntp server (Section 11.2.4.6)
• set timezone (Section 11.2.4.7)
• clear timezone (Section 11.2.4.8)
11.2.4.1 show sntp
Use this command to display SNTP settings.
show sntp
Syntax Description
None.
Command Defaults
None.
Command Mode
Read-Only.