Enterasys 1G58x-09 - Set Radius Accounting

Security Configuration Command Set
Configuring RADIUS
14-12 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
14.3.1.5 set radius accounting
Use this command to configure RADIUS accounting.
set radius accounting
{[enable] [disable] [server index ip_address port
server-secret
] [retries retries index] [timeout timeout index] [intervalminimum
value] [updateinterval value]}
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
enable | disable Enables or disables the RADIUS accounting client.
server index
ip_address port
server-secret
Specifies the accounting server’s:
• index number (1 - 2147483647)
• IP address
• UDP authentication port (0 - 65535)
• server-secret (Read-Write password to access this
accounting server. Device will prompt for this entry
upon creating a server instance, as shown in the example
below.)
retries retries
index
Sets the maximum number of attempts to contact a
specified RADIUS accounting server before timing out.
Valid retry values are 1 - 2147483647.
timeout timeout
index
Sets the maximum amount of time (in seconds) to establish
contact with a specified RADIUS accounting server before
timing out. Valid timeout values are 1 - 2147483647.
intervalminimum
value
Sets the minimum interval at which RADIUS accounting
will send interim updates. Valid values are 60 -
2147483647.
updateinterval
value
Sets the number of seconds between each RADIUS
accounting interim update (when accumulated accounting
data is sent to the server for a session.) Valid values are 180
- 2147483647.